Items Included
|
Tools Required
|
Before You Get Started...
Warm surfaces and 3M tape with heat gun if ambient temperature is below 68 degrees F
|
Any Modification or unintended use will void the manufacturers warranty
|
A dry fit of all pieces must be performed before the final installation of the product to ensure fit
|
Products cannot be returned for a full refund after the red backing to the 3M tape is removed
|
Getting Started
1. Dry-fit your fog lamp bezel overlay by following the instructions below without removing the backing to the 3M double-sided tape. Ensure the part is centered, and make note of its positioning for reference later.
2. Clean the surface of the fog lamp bezel using isopropyl rubbing alcohol.
3. Apply the adhesion promoter to the areas of the fog lamp bezel where the 3M tape will be touching down. (Read the instructions on the adhesion promoter tube to learn how to begin the flow of adhesion promoter.)
4. Remove the backing to all sections of 3M tape
5. With the fog lamp bezel overlay relatively centered on the OE bezel, begin pushing the overlay into place.
6. Ensure the top lip of the overlay tucks under the bottom edge of the grille piece directly above the fog lamp bezel. The sides and the bottom edge of the fog lamp bezel should also tuck into their respective edges.
The Finale
7. Put firm pressure on the taped areas of the BumperShellz, and remove any protective film.
Care for your BumperShellz™
Most BumperShellz colors will function much like paint. They can be buffed, polished, taken through automated car washes, and whatever else you would normally do. Some ABS colors can be sanded down and re-painted if ever you decide you want to change colors. The only color that cannot be polished, and re-painted is the Textured Black TPO.